Permits & Process · November 1, 2026
The B100a Review: Adding On to a House With a Septic System in Connecticut
An addition, a garage, a pool, or a shed on a septic lot needs the health district to sign off first. Here's what Section 19-13-B100a actually asks.

Homeowners find out about B100a the same way every time: they apply for a building permit for an addition, and the building official says the health district has to sign off first. Section 19-13-B100a of the Connecticut Public Health Code applies to any lot without public sewer, which is most of eastern Connecticut outside the village centers. The point of the rule is simple. The state doesn't want you building over the only place a replacement septic system could go.
What triggers a B100a review
- Any addition to the house, bedroom or not. A sunroom, a mudroom, and a bump-out all count.
- Converting a seasonal building to year-round use: adding heat, insulation, or frost-protected water.
- A change in use that raises occupancy or water use, such as an in-law apartment or a home business with customers.
- Attached or detached garages, sheds, barns, and other accessory structures.
- Above-ground and in-ground pools.
- Decks, including open ones.
- Lot line changes or soil disturbance that would reduce the area available for a future repair system.
What the health district has to find
The local director of health has to determine that, after your project, a code-complying area still exists on the lot: a spot where a subsurface sewage system could be installed under Section 19-13-B103 and the Technical Standards, with the usual separations from wells, property lines, watercourses, and foundations. The 100 percent reserve area isn't required for this test, but everything else is. The district makes that call from existing soil data on file. If there's no data, which is common on older houses and anything built before the district kept records, the owner has to get soil testing done: test holes and a percolation test, witnessed by the district.
For additions, there's a fallback if a fully compliant area can't be shown. The project can still be approved if a replacement system could provide at least half the required leaching area and spread, wouldn't need a well-separation exception, wouldn't shrink the repair area, and the addition doesn't increase design flow. For garages, pools, and accessory structures, the test is simpler: don't reduce the repair area, and keep the separation distances in the code's Table 1.
Bedrooms and the 50 percent rule
Septic systems are sized by bedroom count, so the question the district cares most about is whether your addition adds one. A room with a closet and a door, a finished basement with egress, an office that could be a bedroom: districts count these differently, and some have written policies. If the project raises the design flow by more than 50 percent, the director can require the existing system to be expanded or replaced before the addition is approved. Below that, the system can usually stay, provided the code-complying area is there.
Who reviews it in our towns
Sterling, Plainfield, Brooklyn, Canterbury, Killingly, and Putnam go to the Northeast District Department of Health (NDDH) in Brooklyn. Norwich, Lisbon, and Griswold go to the Uncas Health District in Norwich. Each district has its own B100a application form, fee, and review time; a clean file with soil data on record usually clears in a week or two, and a file that needs new testing takes as long as it takes to schedule the sanitarian and the backhoe. The decision has to be in writing, and an adverse decision can be appealed under the public health statutes.
What we do when we're the excavator
Before we quote a foundation for an addition or garage on a septic lot, we pull the district's file on the existing system and walk the lot with the as-built in hand. If the proposed footprint lands on the reserve area, the owner hears it before the plans are drawn, not after the B100a comes back denied. If testing is needed, we dig the test holes for the sanitarian's witness visit, and we keep the machine out of the leach field and the reserve area for the rest of the job. The district's sign-off is a condition of the building permit, so there's no version of this where the paperwork gets skipped and the addition still gets a certificate of occupancy.
- CT DPH: Section 19-13-B100a, building conversions and additions — The regulation text and the state's summary.
- Northeast District Department of Health — B100a applications for Sterling, Plainfield, Brooklyn, Canterbury, Killingly, and Putnam.
- Uncas Health District — B100a applications for Norwich, Lisbon, and Griswold.
- How NDDH septic permits work — The full permit path when a new or replacement system is needed.
Where we run this work
Have a job like this?
